Dimension template
From BelegarthWiki
(Difference between revisions)
| Line 11: | Line 11: | ||
*5. 2" hole for checking pommel diameter | *5. 2" hole for checking pommel diameter | ||
*6. 2.5" hole for checking arrow heads as well as weapon tips | *6. 2.5" hole for checking arrow heads as well as weapon tips | ||
| − | *7. .75" slot cut near a corner for attaching a tape measure | + | *7. .75" slot cut near a corner for attaching a tape measure |
Revision as of 21:28, 4 November 2005
A dimension template is used during weapons check to make sure a weapon fulfills dimension requirements listed in the Book of War.
Here is an example of a template:
Functions:
- 1. 6" side for checking flail chain length
- 2. 3" side for checking sword flat width
- 3. 1.25" notch for checking sword edge width
- 4. 1.5" notch for checking amount of exposed flail chain (no more than 1.5")
- 5. 2" hole for checking pommel diameter
- 6. 2.5" hole for checking arrow heads as well as weapon tips
- 7. .75" slot cut near a corner for attaching a tape measure
